One method of mixing between clipper and shear work is to use the clipper-over-comb method. For this technique, work with a detachable blade clipper with a sizable knife (#1 1/2 or higher). The bigger blade gives the client an easier blend as the hair will be reduce a standard period with a feathered end. Never make use of a short knife or trimmer to mixture because the knives gives the hair a very frank cut and leave plenty of little lines of demarcation.
Yet another method of mixing is blending-shears-over-comb. Carry the hair up with the brush and utilize the blending shears to cut the last 1/4″ of the hair. When training the hair, it is important to slightly overdirect before chopping as this may make a softer blend. Make sure to just reduce the past 1/4 ‘” to 1/8″ of hair. Never thin hair near to the crown as this can develop a fuzzy look by causing tagliocapelliuomo short locks to stand out through the lengthier hairs. Work with a thinning shear with at the very least 40 teeth. Shears with larger teeth can produce lines. Prevent using regular shears to blend since the blades gives the hair an extremely dull reduce and leave plenty of small lines of demarcation.
You can even create a blend utilizing a normal straight razor (without a comb attachment). The hair is raked with the blade at a 45 amount angle. The perspective of the edge is extremely important. If the blade is held in a more flattened position, too much hair will be removed. If the blade is presented more upright, it’ll injury the cuticle. That method was made popular by the Roffler colleges and shouldn’t be tried until you have acquired hands-on teaching with a barber/stylist who’s qualified in the technique. For blade mixing, it is vital that the hair be really wet.
A blade (with guard) or shear-point methods can be used to offer the haircut texture by chopping the ends of the hair in apparent, different lengths. Structure is fascinating in haircuts which are utilized spiked or disheveled. The blade (with guard) is used to strip the ends of the hair involving the knife and the thumb to create the various lengths. When taking the hair between the blade and thumb, contain the razor at an angle and make use of a sweeping motion. The shear-point process is employed to cut the ends of the hair at an angle (or even snipping out alternating pieces) to add texture. Conduct these methods just after hands-on instruction from the qualified instructor.